Ekofires EKO 3080 Guia de Resolução de Problemas

INSTALLATION & USER INSTRUCTIONSAll instructions must be handed to the user for safekeeping.FULL DEPTH RADIANT & CONVECTOR GAS FIRESRevision D

The spark gap (shown in figure 19) between the spark electrode and the thermocoupleshould be 3.5 - 4.5mm to produce a good spark. There sho

Close all doors and windows to the room containing the appliance. Let the fire run on HIGH for five minutes. Take a smoke match, lightit, and using a

12Remove the firefront and place to one side. Remove the ceramic components. Gently clean in the open air. Be careful not to createdust from the coals

Fire sparks but pilot does not light • No gas to fire, check isolators are open and gas supply is on.• Pipework blockage, clean out. • Air not fully

• The installation and Servicing of this fire MUST only be carried out by a competent person in accordance with local Codes and/

The fireguards specified in BS 8423 are intended to protect people from falling into a fire, prevent burns and reduce the risk of injury, particu-larl

The pilot is visible through the left hand side of the front ceramic strip. Rotate the coals or pebbles forgood viewing. Push the slide control knob f

Coal effect models1. Position the combustion matrix onto the burner tray as shown infigure 8. The front edge of the matrix should sit snugly behind t

5. Take another four coals and place behind the second row of coalsas shown in figure 13, in order to complete the third row. The coalsmay be orientat

3. Take five more ceramic pebbles and position as shown to form the‘second row’ of the fuel effect as shown in figure 17. The pebbles may berotat

• This appliance is an Inset Decorative Fuel Effect appliance which provides radiant warmth utilising the latest type burner technology.• The fire is

COALS AND CERAMICS - Remove the firefront and place to one side. Remove the ceram-ic components. Gently clean in the open air. Be careful not to creat

13.0 SERVICE HISTORYAs our policy is one of continuous improvement and development , we hope therefore you will understand we must retain the right to

This appliance MUST NOT be installed into a room containing a bath or shower, or where steam may be present. The fire has beendesigned to fit into a b

4.0 SITE REQUIREMENTS - CONTINUEDGB IE4Note: The spigot outlet of the fire is 565mm high, but should fit into the gather at the top of the fireplace a

No purpose provided ventilation is normally required for this appliance. The requirements of other appliances operating in thesame room or space must

Note: Ensure that the gas supply is isolated before commencinginstallation of the appliance. The fireplace opening and environment must be in

Before installing the fire, check the flue using a smoke pellet. All of the smoke should travel up the flue and exit correctly from the ter-minal. If

All models: Drill four holes using a 8mmmasonry bit to a depth of 42mm in the posi-tions shown in figure 10. If the fireplace con-figuration

The pilot is visible through the viewing hole which is located at the lower left hand side of the fuelbed. The fire features a ‘twin spark’ ignition s